Hardware Specifications |
Hardware Version |
1.0 |
VDSL Interface |
24-port VDSL2 Line via 1 RJ21 (Telco 50) connector 24-port POTS/Telephone via 1 RJ21 (Telco 50) connectors |
Copper Ports |
2 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports |
SFP/mini-GBIC Slots |
2 1000BASE-X SFP interfaces, shared with Port-25 and Port-26 |
Console |
1 RS232-to-RJ45 serial port (115200, 8, N, 1) |
Transient Voltage Suppressor |
IEC 61000-4-2 (ESD): ±8kV (air), ±4kV (contact) IEC 61000-4-4 (EFT): power port 1KV, signal port 0.5KV IEC 61000-4-5 (Lightning): power port 2 KV(1.2/50μs), signal port 1KV(1.2/50μs), 12 ohm |
Switch Architecture |
Store-and-Forward |
Switch Fabric |
8.8Gbps/non-blocking |
Switch Throughput |
6.547Mpps @64bytes |
Address Table |
8K entries |
Shared Data Buffer |
512K bytes |
Maximum Frame Size |
9K bytes |
Flow Control |
Back pressure for half-duplex IEEE 802.3x pause frame for full-duplex |
LED |
VDSL2, PWR, SYS, LNK/ACT, 1000 |
Reset Button |
< 5 sec: System reboot > 10 sec: Factory default |
Dimensions (W x D x H) |
435 x 260 x 67 mm, 1.5U height |
Weight |
4.3 kg |
Power Requirements |
100~240V AC, 50-60 Hz |
Power Consumption/Dissipation |
90 watts (max.) |
VDSL2 |
VDSL2 Standard |
Complies with ITU-T G.993.1 and G.993.2. Supports provisioning the VDSL optional band (25K to 138K Hz) usage |
Band Plan |
Selectable band plan for each VDSL line on a per port basis Band Plan A: - Profile 998, Annex A of G.993.1; optimized for symmetric services Band Plan B: - Profile 997, Annex B of G.993.1; optimized for asymmetric services |
Rate Adaptation |
Manual RaInit Dynamics |
Power Back-Off |
Downstream Power Back-Off (DPBO) PSD Upstream Power Back-Off (UPBO) PSD |
Encoding |
VDSL-DMT |
VDSL2 Template |
Configurable Line Template Configurable Alarm Template |
VDSL2 Features |
Selectable rate limit control Selectable target SNR (Signal to Noise Ratio) mode POTS voices passthrough |
Layer 2 Function |
Management Interface |
Console; Telnet; Web browser; SNMP v1, v2c, v3 |
Gigabit Port Configuration |
Port disable/enable Auto-negotiation 10/100/1000Mbps full and half duplex mode selection Flow control disable/enable |
Gigabit Port Status |
Display each port’s speed duplex mode, link status and flow control status Auto-negotiation status, trunk status |
Port Mirroring |
TX/RX/both 1 to 1 monitor |
Bandwidth Control |
Ingress/Egress rate limit control Gigabit Port: • Allow to configure per 128Kbps VDSL2 Port: • Allow to configure per 5Mbps |
VLAN |
IEEE 802.1Q tag-based VLAN, up to 256 VLAN groups, out of 4094 VLAN IDs Port-based VLAN GVRP, up to 128 dynamic VLAN groups Q-in-Q tunneling Private VLAN Edge (PVE/Protected port) with two protected port groups |
Link Aggregation |
Static port trunk IEEE 802.3ad LACP (Link Aggregation Control Protocol) Supports 13 groups with 8 ports per trunk |
QoS |
4 priority queue Traffic classification based on - Port priority - 802.1p priority - DSCP/TOS field in IP Packet VoIP QoS by application protocol no. |
IGMP Snooping |
IGMP (v1, v2) snooping, up to 256 multicast groups |
Access Control List |
IP-based Layer 3/Layer 4 ACL Up to 220 ACL rule entries |
Security |
Port Security (Disable per port of MAC address learning) Static MAC, MAC filter, IP/MAC binding |
SNMP MIBs |
RFC 1213 MIB-II RFC 2863 Interface MIB RFC 2665 EtherLike MIB RFC 1493 Bridge MIB RFC 2819 RMON MIB (Group 1, 2, 3,9) |
Standards Conformance |
Regulatory Compliance |
FCC Part 15 Class B, CE, VCCI |
Standards Compliance |
IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3z 1000BASE-SX/LX IEEE 802.3ab 1000BASE-T IEEE 802.3x Flow control and back pressure IEEE 802.3ad Port trunk with LACP IEEE 802.1D Spanning Tree Protocol IEEE 802.1w Rapid Spanning Tree Protocol IEEE 802.1p Class of Service IEEE 802.1Q VLAN tagging IEEE 802.1X Port Authentication Network Control ITU-T G.993.1 (VDSL) ITU-T G.997.1 ITU-T G.993.2 VDSL2 RFC 768 UDP RFC 793 TFTP RFC 791 IP RFC 792 ICMP RFC 2068 HTTP RFC 1112 IGMP v1 RFC 2236 IGMP v2 |
Cables |
• VDSL2: twisted-pair telephone wires (AWG24 or better) up to 1km • 10/100BASE-TX: 2-pair UTP Cat.5, up to 100m (328ft) • 1000BASE-T: 4-pair UTP Cat.5E, up to 100m • 1000BASE-SX: 50/125µm and 62.5/125µm fiber-optic cable, up to 550m • 1000BASE-LX: 9/125µm fiber optic cable, up to 10km 50/125µm and 62.5/125µm fiber-optic cable, up to 550m |
Environment |
Operating |
Temperature: -10 ~ 50 degrees C Relative Humidity: 10~ 90% (non-condensing) |
Storage |
Temperature: -20 ~ 70 degrees C Relative Humidity: 10~ 90% (non-condensing) |