| Hardware Specifications |
| 10/100Mbps Copper Ports |
16 10/100Base-TX RJ-45 Auto-MDI/MDI-X ports |
| Gigabit Copper Ports |
2 10/100/1000Base-T RJ-45 Auto-MDI/MDI-X ports |
| SFP/mini-GBIC Slots |
2 1000Base-X SFP interfaces, shared with Port-17 to Port-18 |
| Switch Architecture |
Store-and-Forward |
| Switch Fabric |
7.2Gbps / non-blocking |
| Throughput |
5.35Mpps@64Bytes |
| Address Table |
4K entries, automatic source address learning and ageing |
| Share Data Buffer |
2.75Mb embedded memory for packet buffers |
| Flow Control |
IEEE 802.3x pause frame for full-duplex
Back pressure for half-duplex |
| Jumbo Frame |
1536 Bytes |
| Reset Button |
< 5 sec: System reboot
> 5 sec: Factory Default |
| Dimensions (W x D x H) |
440 x 200 x 44.5 mm, 1U height |
| Weight |
2.55kg |
| LED |
System:
Power (Green)
10/100Base-TX RJ45 Interfaces (Port1 to Port16):
10/100Mbps LNK/ACT (Green)
PoE In-Use (Orange)
10/100/1000Base-T RJ45 / SFP Interfaces (Port17 to Port18):
LNK/ACT (Green)
100/1000 (Green)
PoE Usage
50W, 100W, 150W, 190W (Orange) |
| Cable Twisted-Pair |
10Base-T: 2-Pair UTP CAT. 3, 4, 5, up to 100 meters
100Base-TX: 2-Pair UTP CAT. 5, 5e up to 100 meters
1000Base-T: 4-Pair UTP CAT. 5e, 6 up to 100 meters |
| Cable Fiber-Optic Cable |
1000Base-SX :
50/125μm or 62.5/125μm multi-mode fiber optic cable, up to 550m
(varying on SFP module)
1000Base-LX :
9/125μm single-mode fiber optic cable, up to 10/20/30/40/50/70/120
kilometers (varying on SFP module) |
| Power Requirements |
100~240V AC, 50/60Hz, 4A |
| Power Consumption |
Max. 240 watts / 816 BTU |
| ESD Protection |
2KV DC |
| Power over Ethernet |
| PoE Standard |
IEEE 802.3af / 802.3at PoE / PSE |
| PoE Power Supply Type |
End-span |
| PoE Power Output |
Per Port 56V DC, Max. 30.8 watts |
| Power Pin Assignment |
1/2(+), 3/6(-) |
| PoE Power Budget |
220 watts (max.) |
| PoE Ability PD @ 7 watts |
16 units |
| PoE Ability PD @ 15.4 watts |
12 units |
| PoE Ability PD @ 30.8 watts |
7 units |
| Layer 2 Functions |
| Port Configuration |
Port disable / enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow Control disable / enable |
| Port Status |
Display each port’s speed duplex mode, link status, flow control status, auto negotiation status and trunk status |
| Port Mirroring |
TX / RX / Both
Many-to-1 monitor |
| VLAN |
802.1Q tagged-based VLAN, up to 30 VLAN groups, out of 4094 VLAN IDs
Port-based VLAN, up to 18 VLAN groups
MTU VLAN |
| Link Aggregation |
2 groups of 4-Port 10/100Base-TX trunk supported
1 group of 2-Port 10/100/1000Base-T trunk supported |
| QoS |
Allow to assign low / high priority on each port
First-In-First-Out, All-High-before-Low, Weight-Round-Robin QoS policy |
| IGMP Snooping |
IGMP (v1/v2) Snooping, up to 32 multicast groups |
| Security Control |
MAC address binding
TCP & UDP filter |
| Management Functions |
| Basic Management Interfaces |
Web Browser, SNMP v1 |
| Standards Conformance |
| Regulation Compliance |
FCC Part 15 Class A, CE |
| Standards Compliance |
IEEE 802.3 Ethernet
IEEE 802.3u Fast Ethernet
IEEE 802.3ab Gigabit Ethernet
IEEE 802.3z Gigabit Ethernet
IEEE 802.3x Full-duplex flow control
IEEE 802.1Q VLAN
IEEE 802.1p QoS
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet Plus |
| Environment |
| Operating |
Temperature: 0 ~ 50 degrees C
Relative Humidity: 5 ~ 95% (non-condensing) |
| Storage |
Temperature: -10 ~ 70 degrees C
Relative Humidity: 5 ~ 95% (non-condensing) |
